#
# Sample OpenVPN configuration file for
# home using a pre-shared static key.
#
# '#' or ';' may be used to delimit comments.

# Use a dynamic tun device.
# For Linux 2.2 or non-Linux OSes,
# you may want to use an explicit
# unit number such as "tun1".
# OpenVPN also supports virtual
# ethernet "tap" devices.
dev tun

# Our OpenVPN peer is the office gateway.
remote 1.2.3.4

# 10.1.0.2 is our local VPN endpoint (home).
# 10.1.0.1 is our remote VPN endpoint (office).
ifconfig 10.1.0.2 10.1.0.1

# Our up script will establish routes
# once the VPN is alive.
up ./home.up

# Our pre-shared static key
secret static.key

# Cipher to use
cipher AES-256-CBC

# OpenVPN 2.0 uses UDP port 1194 by default
# (official port assignment by iana.org 11/04).
# OpenVPN 1.x uses UDP port 5000 by default.
# Each OpenVPN tunnel must use
# a different port number.
# lport or rport can be used
# to denote different ports
# for local and remote.
; port 1194

# Downgrade UID and GID to
# "nobody" after initialization
# for extra security.
; user nobody
; group nogroup

# If you built OpenVPN with
# LZO compression, uncomment
# out the following line.
; comp-lzo

# Send a UDP ping to remote once
# every 15 seconds to keep
# stateful firewall connection
# alive.  Uncomment this
# out if you are using a stateful
# firewall.
; ping 15

# Uncomment this section for a more reliable detection when a system
# loses its connection.  For example, dial-ups or laptops that
# travel to other locations.
; ping 15
; ping-restart 45
; ping-timer-rem
; persist-tun
; persist-key

# Verbosity level.
# 0 -- quiet except for fatal errors.
# 1 -- mostly quiet, but display non-fatal network errors.
# 3 -- medium output, good for normal operation.
# 9 -- verbose, good for troubleshooting
verb 3