summaryrefslogtreecommitdiff
path: root/doc/sane-dc25.man
diff options
context:
space:
mode:
authorJörg Frings-Fürst <debian@jff-webhosting.net>2020-03-30 21:30:45 +0200
committerJörg Frings-Fürst <debian@jff-webhosting.net>2020-03-30 21:30:45 +0200
commitee770c2346eb37e0dcb8b6cf3eaacf3d8efd6bbc (patch)
tree58f05092be1a17a939e861f8cadcda1b6ca2ecef /doc/sane-dc25.man
parent0da9e21872802cfc6e975b1ebaf9efb9e5934d84 (diff)
parentfef76e17ed4c607ea73b81279f9ef1d7121be900 (diff)
Merge branch 'release/experimental/1.0.29-1_experimental1'experimental/1.0.29-1_experimental1
Diffstat (limited to 'doc/sane-dc25.man')
-rw-r--r--doc/sane-dc25.man12
1 files changed, 6 insertions, 6 deletions
diff --git a/doc/sane-dc25.man b/doc/sane-dc25.man
index eabe765..889fd2d 100644
--- a/doc/sane-dc25.man
+++ b/doc/sane-dc25.man
@@ -15,15 +15,15 @@ connected. The device name is always "0".
.SH CONFIGURATION
The contents of the
.I dc25.conf
-specify the serial port and baud rate to use. The baud rate
+specify the serial port and baud rate to use. The baud rate
specifies the maximum rate to use while downloading pictures. (The
camera is always initialized using 9600 baud, then switches to the
higher rate). On my 90MHz Pentium, I usually have no problems downloading
-at 115200 baud as long as the system is not excessively busy and
+at 115200 baud as long as the system is not excessively busy and
the "interrupt-unmask flag" is set in the IDE driver (hdparm \-u1).
Supported baud rates are: 9600, 19200, 38400, 57600, and 115200.
.PP
-The dumpinquiry line causes some information about the camera to
+The dumpinquiry line causes some information about the camera to
be printed to stderr during startup. Note: This is not compatible
with saned, so make sure you don't have any dumpinquiry lines if you are
using saned (i.e. scanning on a remote machine using a
@@ -74,7 +74,7 @@ to "/tmp/config:" would result in directories "tmp/config", ".", and
.TP
.B SANE_DEBUG_DC25
If the library was compiled with debugging support enabled, this
-environment variable controls the debug level for this backend.
+environment variable controls the debug level for this backend.
A value of 128 requests maximally copious debug output; smaller
levels reduce verbosity.
@@ -93,7 +93,7 @@ slider that is used to select the picture from the camera may not be
updated immediately.
.PP
More general comments, suggestions, and inquiries about frontends
-or SANE should go to the SANE Developers mailing list
-(see http://www.sane\-project.org/mailing\-lists.html for details).
+or SANE should go to the SANE Developers mailing list
+(see http://www.sane\-project.org/mailing\-lists.html for details).
You must be subscribed to the list, otherwise your mail won't be
sent to the subscribers.