1 files changed, 53 insertions, 0 deletions
diff --git a/backend/st400.conf.in b/backend/st400.conf.in
new file mode 100644
index 0000000..5e29226
--- /dev/null
+++ b/backend/st400.conf.in
@@ -0,0 +1,53 @@
+# the ST400 is fixed to ID 3
+scsi SIEMENS "ST 400" Scanner * * 3 *
+scsi SIEMENS "ST 800" Scanner * * 3 *
+
+# The following options are for testing and bug-hunting.  If your scanner
+# needs one of these options to function reliably, please let me know.
+
+# Maximum amount of data to read in a single SCSI command.  If not set
+# (or set to 0), the backend will read as much data as allowed by the
+# scanner model or the OS.  WARNING: Using this option overrides the
+# hardcoded # maxread limits for all scanner models!  With more than
+# 65536 bytes, my ST400 locks up (itself, the SCSI bus, the sg driver,
+# and the machine). Use with caution.
+#option maxread 65536
+
+# Use this to switch the scanner lights on with a separate MODE SELECT call
+# and wait for some time before starting to scan (to allow the lights to go
+# to full intensity).  The time is in 1/10 seconds (i.e. 20 means 2 seconds).
+# If not set, scanning starts immediately (works with my ST400).
+#option delay 20
+
+# The following are hacks that affect all scanners of the same model as the
+# last attached device.  Used like this (assume ST800's had 8bit depth and
+# 4MB internal buffer):
+#   scsi SIEMENS "ST 400" Scanner * * 3 *
+#   option scanner_bufsize 2097152
+#   option scanner_bits 6
+#   scsi SIEMENS "ST 800" Scanner * * 3 *
+#   option scanner_bufsize 4194304
+#   option scanner_bits 8
+# Currently, the backend has entries for ST400, ST800 and "everything else".
+# To add more scanners, you have to add a line in the st400_models array.
+# Please note that these options are only for testing unknown devices with
+# this backend.
+
+# Internal scanner buffer:
+#option scanner_bufsize 2097152
+
+# Bit depth:
+#option scanner_bits 6
+
+# Maximum bytes to read in a single SCSI command (see also maxread above).
+#option scanner_maxread 65536
+
+# Supported resolutions (upto 15 different values).  If you specify an
+# illegal value here, most likely the scanner will not report an error,
+# but only scan a small sub-area of the requested area (at least my ST400
+# does this).
+#option scanner_resolutions 200 300 400
+
+# This option causes the SCSI inquiry response to be written to
+# "$HOME/st400.dump" (as binary data).  For debugging purposes.
+#option dump_inquiry