diff options
Diffstat (limited to 'doc/sane-artec_eplus48u.man')
| -rw-r--r-- | doc/sane-artec_eplus48u.man | 14 |
1 files changed, 7 insertions, 7 deletions
diff --git a/doc/sane-artec_eplus48u.man b/doc/sane-artec_eplus48u.man index 70f4254..fa6fe7f 100644 --- a/doc/sane-artec_eplus48u.man +++ b/doc/sane-artec_eplus48u.man @@ -6,7 +6,7 @@ The .B sane\-artec_eplus48u library implements a SANE (Scanner Access Now Easy) backend that provides access to several USB flatbed scanners using the GT6816 chipset like the Artec E+ 48U. -These scanners have a contact image sensor (CIS) and an USB interface. +These scanners have a contact image sensor (CIS). .PP A complete list of supported devices can be found on .IR http://www.sane\-project.org/sane\-supported\-devices.html . @@ -57,10 +57,9 @@ autodetected by .I usb vendor_id product_id statements which are already included into .I artec_eplus48u.conf . -"vendor_id" and "product_id" are hexadecimal numbers that identify the -.B scanner. +"vendor_id" and "product_id" are hexadecimal numbers that identify the scanner. .PP -Every usb section can have additional options +Every usb section can have additional options. .TP .B artecFirmwareFile @DATADIR@/sane/artec_eplus48u/Artec48.usb The path to the firmware file. This option is required. @@ -86,8 +85,9 @@ then the gamma options are reset to the values specified here. .B greenExposure 0x116 .TP .B blueExposure 0xdc -These are the default values for offset and exposure time. You can e.g. change them to speed up calibration, -if you don't want to save the calibration data to disk. +These are the default values for offset and exposure time. +You can change them (e.g. to speed up calibration) +if you don't want to save the calibration data permanently. .TP .B vendorString "Artec" .TP @@ -111,7 +111,7 @@ support dynamic loading). .TP .B SANE_CONFIG_DIR This environment variable specifies the list of directories that may -contain the configuration file. Under UNIX, the directories are +contain the configuration file. On *NIX systems, the directories are separated by a colon (`:'), under OS/2, they are separated by a semi-colon (`;'). If this variable is not set, the configuration file is searched in two default directories: first, the current working |