diff options
Diffstat (limited to 'doc/sane-gphoto2.man')
| -rw-r--r-- | doc/sane-gphoto2.man | 21 |
1 files changed, 10 insertions, 11 deletions
diff --git a/doc/sane-gphoto2.man b/doc/sane-gphoto2.man index ef8141f..3e2a046 100644 --- a/doc/sane-gphoto2.man +++ b/doc/sane-gphoto2.man @@ -6,7 +6,7 @@ sane\-gphoto2 \- SANE backend for gphoto2 supported cameras The .B sane\-gphoto2 library implements a SANE (Scanner Access Now Easy) backend that -provides access to the digital cameras supported by gphoto2. +provides access to the digital cameras supported by gphoto2. This backend has only been tested with a handful of cameras so far. Patches to support other models are welcome. .PP @@ -26,16 +26,16 @@ required since they are needed by the sane frontends, but can't be obtained through the gphoto2 interface. Valid ports and cameras can be obtained by "gphoto2 \-\-list\-cameras" and "gphoto2 \-\-list\-ports". .PP -The dumpinquiry line causes some information about the camera to +The dumpinquiry line causes some information about the camera to be printed. .PP Empty lines and lines starting with a hash mark (#) are ignored. A sample configuration file is shown below: .PP -The "topfolder" line specifies the "fixed" part of the file path. For -example, on the Kodak DC-240, files are stored in the directory +The "topfolder" line specifies the "fixed" part of the file path. For +example, on the Kodak DC-240, files are stored in the directory /DCIM/100DC240. The /DCIM portion is constant, but 100DC240 will -change and must be read from the camera. In this case, the +change and must be read from the camera. In this case, the line would read "topfolder=/DCIM" .PP Some cameras don't implement a file structure and store all pictures @@ -90,12 +90,12 @@ to "/tmp/config:" would result in directories "tmp/config", ".", and .TP .B SANE_DEBUG_GPHOTO2 If the library was compiled with debugging support enabled, this -environment variable controls the debug level for this backend. +environment variable controls the debug level for this backend. A value of 128 requests maximally copious debug output; smaller levels reduce verbosity. -.TP +.TP .B GP_DEBUG -Set to 1, 2, or 3, to enable various levels of debugging within the +Set to 1, 2, or 3, to enable various levels of debugging within the gphoto2 libraries. .SH "SEE ALSO" @@ -111,8 +111,7 @@ The manpage was largely copied from the dc210 manpage. Many, no doubt. .PP More general comments, suggestions, and inquiries about frontends -or SANE should go to the SANE Developers mailing list -(see http://www.sane\-project.org/mailing\-lists.html for details). +or SANE should go to the SANE Developers mailing list +(see http://www.sane\-project.org/mailing\-lists.html for details). You must be subscribed to the list, otherwise your mail won't be sent to the subscribers. - |