diff options
Diffstat (limited to 'doc/sane-magicolor.man')
| -rw-r--r-- | doc/sane-magicolor.man | 32 |
1 files changed, 16 insertions, 16 deletions
diff --git a/doc/sane-magicolor.man b/doc/sane-magicolor.man index 1e6c0a5..17ef387 100644 --- a/doc/sane-magicolor.man +++ b/doc/sane-magicolor.man @@ -10,21 +10,21 @@ backend supports KONICA MINOLTA magicolor scanners connected via USB or LAN. Cur The following scanner should work with this backend: Device Details -.br +.br \-\-\-\-\-\-\-\-\-\-\-\-\-\-\-\-\-\-\-\-\-\-\-\-\-\-\-\-\- -.br +.br Vendor: KONICA MINOLTA -.br +.br Model: magicolor 1690MF .SH "CONFIGURATION" -.PP +.PP This section describes the backend's configuration file entries. The file is located at: -.IP +.IP .I @CONFIGDIR@/magicolor.conf -.PP +.PP For a proper setup, at least one of the following entries are needed: -.IP +.IP .I net autodiscovery .br .I net [IP ADDRESS] [DEVICE-ID] @@ -34,22 +34,22 @@ For a proper setup, at least one of the following entries are needed: .I usb [VENDOR-ID] [DEVICE-ID] .SH "FILES" -.TP +.TP .I @CONFIGDIR@/magicolor.conf The backend configuration file -.TP +.TP .I @LIBDIR@/libsane\-magicolor.a The static library implementing this backend. -.TP +.TP .I @LIBDIR@/libsane\-magicolor.so The shared library implementing this backend (present on systems that support dynamic loading). .SH "ENVIRONMENT" -.TP +.TP .B SANE_CONFIG_DIR This environment variable specifies the list of directories that may contain the configuration file. Under UNIX, the directories are separated by a colon (`:'), under OS/2, they are separated by a semi\-colon (`;'). If this variable is not set, the configuration file is searched in two default directories: first, the current working directory (".") and then in @CONFIGDIR@. If the value of the environment variable ends with the directory separator character, then the default directories are searched after the explicitly specified directories. For example, setting .B SANE_CONFIG_DIR to "/tmp/config:" would result in directories "/tmp/config", ".", and "@CONFIGDIR@" being searched (in this order). -.TP +.TP .B SANE_DEBUG_MAGICOLOR If the library was compiled with debug support enabled, this environment variable controls the debug level for this backend. Higher debug levels increase the verbosity of the output. @@ -59,14 +59,14 @@ To obtain debug messages from the backend, set this environment variable before Example: SANE_DEBUG_MAGICOLOR=65 xscanimage .SH "KNOWN BUGS AND RESTRICTIONS" -.PP +.PP Large color scans may sometimes timeout due to unknown reasons (the scanner simply stops returning data) -.PP +.PP Cancelling large scans may lock up the scanner. .SH "SEE ALSO" .BR sane (7), -.br +.br .I http://wiki.kainhofer.com/hardware/magicolor_scan .SH "AUTHOR" -.PP +.PP Reinhold Kainhofer <reinhold@kainhofer.com> |