diff options
Diffstat (limited to 'doc/sane-scsi.man')
| -rw-r--r-- | doc/sane-scsi.man | 20 |
1 files changed, 10 insertions, 10 deletions
diff --git a/doc/sane-scsi.man b/doc/sane-scsi.man index bcb7d77..5a27555 100644 --- a/doc/sane-scsi.man +++ b/doc/sane-scsi.man @@ -21,9 +21,9 @@ to the generic SCSI device that the scanner is connected to. In this case, the configuration file simply lists the line .BR /dev/scanner . For a detailed description of each backend's configuration file, -please refer to the relevant backend manual page (e.g., +please refer to the relevant backend manual page (e.g., .BR sane\-epson (5) -for Epson scanners, +for Epson scanners, .BR sane\-hp (5) for HP scanners, etc.). .PP @@ -65,7 +65,7 @@ will be probed by the backend one by one and registered if the backend thinks it is a compatible device. For example, the line .PP .RS -scsi MUSTEK MFS\-06000CX Scanner 0 00 03 00 +scsi MUSTEK MFS\-06000CX Scanner 0 00 03 00 .RE .PP would attach the Mustek SCSI scanner with the following /proc/scsi/scsi entry: @@ -84,7 +84,7 @@ Usually it's sufficient to use vendor and model strings only or even only the vendor string. The following example .PP .RS -scsi MUSTEK * * * * * * +scsi MUSTEK * * * * * * .RE .PP would have the effect that all SCSI devices in the system with a @@ -188,10 +188,10 @@ version 2.2.7 on. If the new SG driver is available some backends buffers. If a backend does not automatically request a larger scsi buffer, set the environment variable .B SANE_SG_BUFFERSIZE -to the desired buffer size in bytes. It is not recommended to use more -than 1 MB, because for large values the probability increases that the -SG driver cannot allocate the necessary buffer(s). For ISA cards, even -1 MB might be a too large value. For a detailed discussion of memory +to the desired buffer size in bytes. It is not recommended to use more +than 1 MB, because for large values the probability increases that the +SG driver cannot allocate the necessary buffer(s). For ISA cards, even +1 MB might be a too large value. For a detailed discussion of memory issues of the SG driver, see http://www.torque.net/sg. .PP For Linux kernels before version 2.2.7 the size of the buffer is only 32KB. @@ -266,7 +266,7 @@ therefore while a scan is in progress, the system becomes almost unusable. You may change the values of the USLEEP macros in drivers/scsi/g_NCR5380.c. Some documentation is in this file and NCR5380.c. .TP -NCR/Symbios 810 +NCR/Symbios 810 For some scanners it may be necessary to disable disconnect/reconnect. To achieve this use the option ncr53c8xx="disc:n". Some people reported that their scanner only worked with the 53c7,8xx driver, not the ncr53c8xx. Try @@ -315,7 +315,7 @@ of 255 also prints kernel messages from the SCSI subsystem (where available). Smaller levels reduce verbosity. .TP .B SANE_SCSICMD_TIMEOUT -sets the timeout value for SCSI commands in seconds. Overriding the default +sets the timeout value for SCSI commands in seconds. Overriding the default value of 120 seconds should only be necessary for very slow scanners. .SH "SEE ALSO" |