From 58912f68c2489bcee787599837447e0d64dfd61a Mon Sep 17 00:00:00 2001 From: =?UTF-8?q?J=C3=B6rg=20Frings-F=C3=BCrst?= Date: Wed, 24 May 2017 21:03:56 +0200 Subject: New upstream version 1.0.27 --- backend/pixma.conf.in | 15 +++++++++++++-- 1 file changed, 13 insertions(+), 2 deletions(-) (limited to 'backend/pixma.conf.in') diff --git a/backend/pixma.conf.in b/backend/pixma.conf.in index a275b03..3f5c61a 100644 --- a/backend/pixma.conf.in +++ b/backend/pixma.conf.in @@ -1,5 +1,11 @@ # pixma.conf configuration for the sane pixma backend # +# bjnp-timeout=5000 +# Specify the timeout (in ms) to be used for all the folllowing +# scanners. +# May be specified multiple times. +# The last value (if any) will be used for auto-detection +# # define URI's of scanners (one per line) # This is only used for network scanners. # normally scanners will be detected by sending a broadcast @@ -8,7 +14,12 @@ # # method must be bjnp # port number can normally be left out, port 8612 is used as default +# The timeout parameter sets a timeout value for the scanner on +# the same line # Example: -# bjnp://myscanner.my.domain:8612 -# bjnp://printer-1.pheasant.org +# bjnp://myscanner.my.domain:8612 // uses the default 1000ms timeout +# bjnp-timeout=5000 +# bjnp://printer-1.pheasant.org // will use the 5000 ms timeout +# bjnp://scanner.bad-network.org/timeout=1500 // timeout set to 1500 ms +# bjnp-timeout=3000 // will be used for auto-detected scanners # -- cgit v1.2.3