# XTrkCad Version: 3.0.1, Date: Sat Sep 23 23:40:39 2000 VERSION 10 DEMOINIT ORIG 4.000 0.000 0.000 PARAMETER display description-fontsize 64 REDRAW RESET MESSAGE You can draw a variety of different types of benchwork: - rectangular (1x2, 2x4 etc) - L girders - T girders You can also draw them in different orientations. END STEP COMMAND DrawBench PARAMETER draw benchcolor 16760832 PARAMETER draw benchlist 0 1"x1" PARAMETER draw benchorient 0 On Edge PARAMETER GROUP draw PARAMETER draw benchlist 12 L-2"x4" PARAMETER draw benchlist 16 L-3"x6" MESSAGE _________________________________________ We will draw two 3x6 inch L-girders. END STEP MOUSE 2 0.000 2.000 MOUSE 4 23.812 2.000 PARAMETER draw benchcolor 16760832 PARAMETER draw benchlist 16 L-3"x6" PARAMETER draw benchorient 0 Left PARAMETER GROUP draw MOUSE 2 0.000 10.250 MOUSE 4 23.750 10.250 PARAMETER draw benchcolor 16760832 PARAMETER draw benchlist 16 L-3"x6" PARAMETER draw benchorient 0 Left PARAMETER GROUP draw MESSAGE _________________________________________ The flange of the top L-Girders is on the outside edge of the girders. We want to change the girder so both flanges are on the inside. We will use the command for this. END STEP COMMAND Describe MOUSE 2 12.312 10.500 MOUSE 4 12.312 10.500 MESSAGE _________________________________________ Change the Orientation to Right. END STEP PARAMETER describe L2 1 Right PARAMETER describe ok RESET MESSAGE _________________________________________ Now both flanges are on the inside of the two girders. ========================================= END REGRESSION START 10 - benchwork DRAW 1 0 0 0 0 0.000000 0.000000 0 0.000000 B3 16760832 0.055556 0.000000 2.000000 0 23.812000 2.000000 0 17173504 END DRAW 2 0 0 0 0 0.000000 0.000000 0 0.000000 B3 16760832 0.055556 0.000000 10.250000 0 23.750000 10.250000 0 17173505 END REGRESSION END STEP CLEAR